How to Apply Pink Pepper & Vetiver for Even Coverage

Quick answer

Apply Pink Pepper & Vetiver in two or three thin coats, using a loaded brush and a light touch. Let each coat dry completely before adding the next to avoid streaks and uneven coverage.

Step-by-step application for even coverage

1. Start with a clean, dry nail: Wipe each nail with a lint-free pad and a small amount of rubbing alcohol or nail polish remover. Let it dry completely. Skip this and oils or residue will cause the polish to pull away and streak.
2. Load the brush lightly: Dip the brush and wipe one side against the bottle neck so only one side holds polish. Do not scrape both sides. A properly loaded brush prevents flooding and gives you control.
3. Apply a thin base coat: Use a base coat if you have one, but keep it thin. Let it dry for two minutes before moving on. A thick base coat will make the color coat slide and pool.
4. Paint the first thin color coat: Start at the center of the nail near the cuticle and pull the brush straight to the tip in one smooth stroke. Then paint the left and right sides without reloading. Do not press hard; let the brush glide. Pressing causes streaks.
5. Let the first coat dry: Wait at least five minutes, or until the surface is tacky but not wet, before applying the second coat. Applying a second coat too soon will drag the first coat and create patches.
6. Apply a second thin coat: Repeat the same stroke pattern with a freshly loaded brush. If you still see streaks, add a third thin coat rather than a thick one. Two thin coats usually cover better than one thick coat.
7. Finish with a top coat: Apply a thin top coat, wrapping the tip of the nail to seal the edge. Let it dry fully. A top coat smooths minor streaks and adds shine.

Product facts

• Pink Pepper & Vetiver: Hand-poured soy candle with cotton wick and custom matches included. This is a candle for burning, not a nail polish, so the application steps below do not apply to this product.